IBM A00 Setting Up Front Push Forms Path (Default), Setting Front Push Tractor

The front forms-tractor and rear forms-tractors are interchangeable. Either forms
tractor can be used in either location after you have set it for the forms path you
have selected.
Setting Up Front Push Forms Path (Default)
Figure 6 shows the Front Push forms path with the Manual Sheet Feed forms path.
Setting Front Push Tractor
The Front Push forms tractor should be set to position (2), as shown in Figure 7on
page 15.
If the tractor is set to position (1), perform the following:
1. Hold the tractor face-down with the electrical connector tab on the right side,
and pointing toward you.
2. Pull the bottom release levers toward you with your finger tips and push the
movable edge of the tractor down toward the flat surface with your thumbs or
the palms of your hands (position 2).
Figure 6. Front Push Forms Path (with Manual Sheet Feed)
14 4247 Printer ModelA00 User’s Guide