6. Press ↓until the message AUTO LF=xxxx displays, where xxxx can be NO or YES.
If you want to select a value other than the one displayed, press ←or →.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
20 CPI
Youcan set the printer to allow 20 CPI condensed print from the data stream. For
more information, see “Shift In (SI) / Condensed Print” on page190. You can set
this value to:
No (default) A combination of 12 CPI and a condensed print data stream
command (Shift In) sets the printer to 12 CPI.
Yes A combination of 12 CPI and a condensed print data stream
command (Shift In) sets the printer to 20 CPI.
Tochange or check the 20 CPI value:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A.
6. Press ↓until the message 20 CPI=xxx displays, where xxxx can be NO or YES.If
you want to select a value other than the one displayed, press ←or →.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
NLQ
Note: Using NLQ reduces printer throughput by approximately 50%.
Youcan change the font for Near Letter Quality (NLQ) printing, available through
the operator panel Font key, to either of the following values:
vCourier (default)
vGothic
Tochange or check the NLQ font value:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A.
6. Press ↓until the message NLQ=xxxxxxx displays, where xxxxxxx can be COURIER
or GOTHIC. If you want to select a value other than the one displayed, press ←or
→.
98 4247 Printer ModelA00 User’s Guide