Remote Printer is connected remotely to a host computer through an
external modem.
Tochange or check the Connection Type:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A.
6. Press ↓until the message CONNECT=xxxxxx displays, where xxxxxx can be LOCAL
or REMOTE. If you want to select a value other than the one displayed, press ←or
→.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Buffer SizeYoucan set the buffer to one of the following values:
v256
v2K
v12K
v32K (default)
v64K
Tochange or check the Buffer Size:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A.
6. Press ↓until the message BUFFER=xxx displays, where xxx can be 256,2K,12K,
32K,or64K. If you want to select a value other than the one displayed, press ←
or →.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
EmulationYoucan set the emulation type to any of the following values:
vNative 4247 (default)
v4202 III XL
v2381
vEpson FX
Tochange or check the Emulation type:
94 4247 Printer ModelA00 User’s Guide