3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A.
6. Press ↓until the message LANG=xxxxxxxx displays, where xxxxxxxx can be
CP437 through CP1098 when emulation is set Native 4247, 4202 III XL, or 2381
or where xxxxxxxx can be USA through CP1098 when emulation is set to Epson
FX. If you want to select a value other than the one displayed, press ←or →.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Automatic Carriage Return on Line Feed
Youcan set the printer to perform an automatic carriage return on a line feed. You
can set this value to:
No (default) No automatic carriage return is performed at a line feed.
Yes An automatic carriage return is performed after a line feed.
Tochange or check the Automatic Carriage Return after Line Feed:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A.
6. Press ↓until the message AUTO CR=xxx displays, where xxx can be NO or YES.If
you want to select a value other than the one displayed, press ←or →.
7. Toexit from Power On Configuration, press Menu/Enter. Your new value is
stored in NVM.
Automatic Line Feed on Carriage Return
Youcan set the printer to perform an automatic line feed on carriage return. You
can set this value to:
No (default) No line feed is performed after a carriage return.
Yes An automatic line feed is performed after a carriage return.
Tochange or check the Automatic Line Feed on Carriage Return:
1. Ensure the printer is powered off (O).
2. Press and hold Menu/Enter while powering on (|) the printer. The message
STARTING UP displays.
3. After start-up is complete, release Menu/Enter and the message PRINT OUT=NO
displays.
4. Press ↓until the message SERIAL INTERFACE displays.
5. Press →until the message INTF=xxxxxxxxx displays, where xxxxxxxxx can be
SERIAL NO,RS-232C,orRS-422A.
Chapter4. Configuring Your Printer 97