APPN Configuration Command DetailEnable/Disable
Use the enable/disable command to enable (or disable):
Syntax:
enable appn
[or disable] dlur
port

port name

Set
Use the set command to set:
Syntax:
set node
Youwill be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
Table4. Configuration Parameter List - APPN Routing
Parameter Information
Parameter
EnableAPPN
ValidValues
Yes,No
Default Value
Yes
Description
This parameter enables or disables the router as anAPPN network node.
This parameter enables bothAPPN and HPR routing capability for this network node
which consists of defining the Network ID and CP name for this node.APPN, however,
must be enabled on the particular ports on which you desire to supportAPPN routing.
Additionally,support for HPR must be enabled on the particular APPN ports desired
and must be supported by the particular link stations on those ports.
Note: HPR only supported on LAN, frame relay and PPP direct DLC ports.
APPN Configuration Commands
Chapter2. Configuring and Monitoring APPN 83