Example:
show adjacent nodes status
This example shows the detailed routing information on all adjacent nodes.
Only nodes with one hop will be shown. The node type is known and
displayed for adjacent nodes only since this information is contained in hello
messages only.
Adjacent Node Volatile Status
Executor node = 2.26 (gato)
State = on
Physical address = AA-00-04-00-1A-08
Type = DEC-area
Node State Type Cost Hops Circuit Next
Addr Node
2.14 reachable routing IV 3 1 Eth/0 2.14
2.34 reachable routing IV 2 1 PPP/0 2.34
2.42 reachable nonrouting IV 2 1 PPP/0 2.42
1.22 reachable area 3 1 Eth/0 1.22
Show/List
Use the show circuit command to retrieve information on the current state of the
specified circuits from the volatile database. The list circuit command retrieves the
data that is stored in the permanent data base for circuits.
Syntax:
show all
area
circuit...
executor...
known
argument
module
argument
node
argument
Syntax:
list all
area
circuit
argument
executor
argument
module
node
argument
circuit-specifier
argument
Where the circuit-specifiers options are the following:
active circuits
Specifies all circuits that are currently on (per the volatile database).
all circuits
Specifies all circuits on the router.
circuit name
Specifies the named circuit.
DNA IV Configuration and Monitoring Commands
Chapter8. Configuring and Monitoring DNA IV 277