Table29. Configuration Parameter List - LEN End Node LU Name
Parameter Information
Parameter
fully-qualified LU name
ValidValues
fully-qualified (explicit) LU name Generic (partially explicit) LU name Wildcard entry
Astring of up to 17 characters in the form of
netID.LUname
, where:
v
netID
is a network ID from 1 to 8 characters
v
LUname
is a control point name from 1 to 8 characters
Each name must conform to the following rules:
vFirst character:A to Z
vSecond to eighth characters:A to Z, 0 to 9
Note: An existing fully-qualified LU name, using the special characters @, $, and #
from the character setA, continues to be supported; however, these characters should
not be used for new LU names.
Toreduce the number of fully-qualified LU names you need to specify, you can define a
generic LU name using the wildcard character (*) to represent a portion of the LU name
(
LUname
). Youcan also define a wildcard entry by using the wildcard character as the
whole LU name.
Default Value
None
Description
This parameter specifies the fully-qualified names of LUs associated with a LEN end
node. The specified LU names are registered in the network node’s directory services
database. If a name is not registered, the network node cannot locate the LU (unless
the LU name is the same as the CP name of the LEN end node).
Youneed to specify a fully-qualified LU name, which consists of a network ID and the
LU name. The network ID is the name of the network that contains the adjacent LEN
end node. The LU name is the name of a logical unit accessible through the adjacent
LEN end node.
Syntax:
add connection-networkYouwill be prompted to enter values for the following parameters. The
parameter range will be shown in parentheses ( ). The parameter default
will be shown in square brackets [ ].
APPN Configuration Commands
Chapter2. Configuring and Monitoring APPN 173