Example: dump 0
View for interface 0
Dest net Cost State Next hop Zone
214-214 1 Good 152/152 "eth-214"
153-153 0 Dir "eth153"
152-152 0 Dir "ser152"
3 entries
Dest Net
Specifies the destination network number, in decimal.
Cost Specifies the number of router hops to this destination network.
State Specifies the state of the entry in the routing table. It includes the following:
Next hop
Specifies the next hop for packets going to networks that are not directly
connected. For directly-connected networks, this is node number 0.
Zone(s)Specifies the human-understandable name for that network. The zone
name(s) is enclosed in double quotes in case there are embedded spaces
or non-printing characters. If the zone name contains characters beyond the
7-bit ASCII character set (they are 8-bit), the zone name that displays will
depend on the characteristics of your monitoring terminal.
Interface
Use the interface command to display the addresses of all the interfaces in the
router on which AppleTalkPhase 2 is enabled. If the interface is present in the
router but is disabled, this command shows that status.
Note: interface
interface#
displays the active filtering for that interface. It displays
net, node, default zone, and active filters for one interface.
Syntax:
interface
Example: interface
Interface Addresses
PPP/0 0/1 on net 1000-1000 default zone "SerialL ine"
Eth/0 10/52 on net 10-19 default zone "Sales"
PPP/1 0/0 in startup range
TKR/0 0/0 on net 20-29 default zone "Backbone"
Youcan also enter the interface command followed by a specific interface number
to view the AP2 configuration of that interface.
Example: interface 1
Eth/0 1/30 on net 1-5 default zone "marketing"
Input Net filters inclusive 1-5
Output Zone filters inclusive "finance"
Output Net filters exclusive 1-5

AppleTalkPhase 2 Monitoring Commands (Talk 5)

232 MRS V3.2 Protocol Config Ref Vol2