
Table4. Configuration Parameter List - APPN Routing (continued)
Parameter Information
Parameter
Network ID (required)
ValidValues
Astring of 1 to 8 characters:
vFirst character:A to Z
vSecond to eighth characters:A to Z, 0 to 9
Note: Anetwork identifier for an existing network, of which this router network node is
to become a member,using the special characters @, $, and # from the character set
A, continues to be supported; however,these characters should not be used for new
network IDs.
Default Value
None
Description
This parameter specifies the name of theAPPN network to which this network node
belongs. The network ID must be the same for all network nodes in theAPPN network.
AttachedAPPN end nodes and LEN end nodes can have different network IDs.
Parameter
Control point name (required)
ValidValues
Astring of 1 to 8 characters:
vFirst character:A to Z
vSecond to eighth characters:A to Z, 0 to 9
Note: An existing CP name that this node would be acquiring, using the special
characters @, $, and # from the character setA, continues to be supported; however,
these characters should not be used for new CP names.
Default
None
Description
This parameter specifies the name of the CP for thisAPPN network node. The CP is
responsible for managing theAPPN network node and its resources. The CP name is
the logical name of theAPPN network node in the network. The CP name must be
unique within theAPPN network identified by the Network ID parameter.
APPN Configuration Commands
84 MRS V3.2 Protocol Config Ref Vol2