Configuration Changes That Require the APPN Function to Restart
vNetwork ID of the network node
vControl point name of the network node
vXID number (of network node) for subarea connection
vAdjacent node type (of link station)
vChange of node function (EBN, BN, NN)
vAny parameters under the following options:
– High-Performance Routing (HPR) at the node level
– Dependent LU Requester (DLUR) at the node level
– Connection network
– Class of service
– Node tuning
– Node management
– Focal points
– Mode name mappings
– Delete TN3270E parameters
– Routing lists
– COS mapping tables
Configuration Requirements for APPNAPPN routing is configured on the individual adapters supporting the DLC desired.
Touse APPN routing, at least one of the following DLCs must be configured and
enabled:
vLAN ports:
– Token-ring
– Ethernet
vSerial ports configured with:
– PPP
– Frame relay
– X.25
– SDLC
– Dial circuits over ISDN
– Dial circuits over V.25bis
– Dial circuits over V.34
vDLSw
vATM
vHPR over IP
Configuring the Router as an APPN Network NodeYoucan configure the router as an APPN network node in one of three ways,
depending on the level of connectivity you desire with other nodes.
vMinimum configuration
vInitiate connections configuration
vControlling connections configuration
APPN
26 MRS V3.2 Protocol Config Ref Vol2
|