Table23. Configuration Parameter List - Link Station - Detail (continued)
Parameter Information
Parameter
fully-qualified CP name of adjacent node
ValidValues
Astring of up to 17 characters in the form of
netID.CPname
, where:
v
netID
is a network ID from 1 to 8 characters
v
CPname
is a control point name from 1 to 8 characters
Each name must conform to the following rules:
vFirst character:A to Z
vSecond to eighth characters:A to Z, 0 to 9
Note: An existing fully-qualified CP name, using the special characters @, $, and from
the character setA, continues to be supported; however, these characters should not
be used for new CP names.
Default Value
None
Description
This parameter specifies the fully-qualified CP name of the adjacent node. For the
cases where this parameter is not required, the adjacent node’s CP name may be
learned dynamically during XID exchange; however,if a CP name is specified, it must
match the adjacent node’s definition for the link to be successfully activated.
Note: This parameter is required when any of the following occur:
vThe
Service any node
parameter is set to Disable.
vThe
Adjacent node type
parameter is set to LEN end node.
vThe
CP-CP session level security
parameter is set to Enable.
vThe link is a limited resource.
Parameter
Activate link automatically
If limited resource, then this parameter is set to No and is not configurable.
ValidValues
Yes,No
Default Value
Yes
Description
When this parameter is enabled, the router network node automatically activates the
link to the adjacent node and initiates a connection.
APPN Configuration Commands
Chapter2. Configuring and Monitoring APPN 153