2The alternate route is interface 4 and is disabled
3Destination of WAN reroute is NN6
4Configure WAN reroute primary and alternate
5Add the APPN port to NN22
6Link station on APPN port (NN22)
7Primary port
8Alternate port
9Alternate station to NN6
10 Primary station to NN6
11 Destination configuration
12 APPN port on destination; link station will be dynamically created when WAN
reroute occurs.
Configuring WAN Restoral
The following example shows APPN over a primary PPP link. ForAPPN, no unique
definitions are needed. Both sides of the communication link are enabled for WAN
restoral and are similarly configured.
*************************************************************************
*** Configuration of NN6 with a Wan Restoral link to NN35
*** interface 1 is the primary, interface 8 is the Secondary
*** NN35 must also have Wan Restoral configured for its primary/secondary
*** interfaces
**** Note that for APPN, there are NO unique definitions needed.
*************************************************************************
Circuit configuration
FR Config>li al
Base net = 6
Destination name = 2210-35
Circuit priority = 8
Inbound destination name = 2210-35
Inbound calls = allowed
Idle timer = 0 (fixed circuit)
SelfTest Delay Timer = 150 ms
FR Config>ex
Config>fea wan
WAN Restoral user configuration
WRS Config>li all
WAN Restoral is enabled. 1
Default Stabilization Time: 0 seconds
Default First Stabilization Time: 0 seconds
Secondary
Primary Interface Secondary Interface Enabled
----------------------- ----------------------- --------
1 - WAN PPP 8 - PPP Dial Circuit Yes
[No Primary-Alternate pairs defined ]
WRS Config>ex
Config>p appn
APPN user configuration
APPN config>li al
NODE:
NETWORK ID: STFNET
CONTROL POINT NAME: NN6
XID: 00000
APPN ENABLED: YES
MAX SHARED MEMORY: 4096
MAX CACHED: 4000
DLUR:
DLUR ENABLED: YES
PRIMARY DLUS NAME: NETB.MVSC
APPN
Chapter1. APPN 59