NHRP Monitoring Commands
This section explains all of the NHRP monitoring commands as shown in Table64.
Enter the commands from the NHRP> prompt.
Table64. NHRP Monitoring Command Summary
Command Function
? (Help) Displays all the commands available for this command level
or lists the options for specific commands (if available). See
“Getting Help” on page xxvi.
Box Status Displays NHRP enable/disable status.
Interface Status Displays NHRP interface status.
Statistics Displays NHRP interface statistics.
Cache Displays NHRP resolution cache entries.
Server_purge_cache Displays NHRP server_purge_cache entries.
MIB Displays MIB information.
LANE Shortcuts DisplaysLANE shortcut entries.
CONFIG Parameters Displays,changes or resets NHRP configuration
information.
Reset Dynamically reconfigure NHRP interfaces or protocol.
Exit Returns you to the previous command level. See “Exiting a
Lower Level Environment” on page xxvii.
Box Status
Use the box status command to display NHRP status as configured for the box (for
example, all interfaces not explicitly defined).
Syntax:
box-status
Example:
box status
Box level NHRP is ON by config
Interface Status
Use the interface status command to display NHRP status on interfaces.
Syntax:
interface-status
Example:
interface status
Interface 0: UP (NHRP enabled)
Interface 1: UP (NHRP disabled)
Interface 2: DOWN
Interface 3: UP (NHRP LANE Shortcut Interface)
Statistics
Use the statistics command to display NHRP statistics for all interfaces or for a
specific interface.
NHRP Monitoring Commands (Talk 5)
Chapter12. Configuring and Monitoring NHRP 369