Chapter 4. Configuring and Monitoring AppleTalk Phase 2
This chapter describes the AppleTalkPhase 2 (AP2) configuring and monitoring
commands. It includes the following sections:
v“Accessing the AppleTalkPhase 2 Configuration Environment”
v“AppleTalkPhase 2 Configuration Commands”
v“Accessing the AppleTalkPhase 2 Monitoring Environment” on page 229
v“AppleTalkPhase 2 Monitoring Commands” on page 229

Accessing the AppleTalk Phase 2 Configuration Environment

Toaccess the AppleTalk Phase 2 configuration environment, enter the following
command at the Config> prompt:
Config> ap2
AP2 Protocol user configuration
AP2 Config>

AppleTalk Phase 2 Configuration Commands

This section describes the AppleTalkPhase 2 configuration commands.
The AppleTalkPhase 2 configuration commands allow you to specify network
parameters for router interfaces that transmit AppleTalkPhase 2 packets. The
information you specify with the configuration commands becomes activated when
you restart the router.
Enter the AppleTalkPhase 2 configuration commands at the AP2 config> prompt.
Table51 shows the commands.
Table51. AppleTalk Phase 2 Configuration Commands Summary
Command Function
? (Help) Displays all the commands available for this command level or
lists the options for specific commands (if available). See
“Getting Help” on page xxvi.
Add Adds zone names, network filters, and zone filters to an
interface.
Delete Deletes the zone names, interfaces, network filters, and zone
filters.
Disable Disables interfaces, checksumming, split-horizon routing,
network filters, or zone filters, or globally disablesAppleTalk
Phase 2.
Enable Enablesinterfaces, checksumming, split-horizon routing,
network filters, zone filters, or globally enablesAppleTalk
Phase 2.
List Displays the current AppleTalk Phase 2 configuration.
Set Sets the cache size, network range, and node number.
Exit Returns you to the previous command level. See “Exiting a
Lower Level Environment” on page xxvii.
© Copyright IBM Corp. 1994, 1998 221