CONNECTION NETWORK:
CN NAME LINK TYPE PORT INTERFACES
-------------------------------------------------------------
COS:
COS NAME
--------
BATCH
BATCHSC
CONNECT
INTER
INTERSC
CPSVCMG
SNASVCMG
USRBAT
USRNOT
MODE:
MODE NAME COS NAME
---------------------
USRBAT USRBAT
USRNOT USRNOT
PORT:
INTF PORT LINK HPR SERVICE PORT
NUMBER NAME TYPE ENABLED ANY ENABLED
------------------------------------------------------
0 TR000 IBMTRNET YES YES YES
**** < This is the port that will get backed up
1 PPP001 PPP YES YES YES 2
2 SS SDLC NO YES YES
3 SDLC NO YES NO
4 PPP YES YES NO
5 TR005 IBMTRNET YES YES YES
254 DLS NO YES NO
17 PPP017 PPP YES YES YES
9 PPP009 PPP YES YES YES
STATION:
STATION PORT DESTINATION HPR ALLOW ADJ NODE
NAME NAME ADDRESS ENABLED CP-CP TYPE
------------------------------------------------------------
TONN1 TR000 0004AC4E7505 YES YES 1
TONN2 TR000 550020004020 YES YES 1
TONN9 TR000 0004AC4E951D YES YES 1
TOPC4 TR000 0004AC9416B4 YES YES 1
TOVTAM1 TR000 400000003888 YES YES 1
**** < this linkstation will get backed up
TONN35 PPP001 000000000000 YES YES 0 3
TO15DOD PPP009 000000000000 YES NO 0
LU NAME:
LU NAME STATION NAME CP NAME
------------------------------------------------------------
APPN config>ex
Config>
*logout
Connection closed.
Note:

1WAN restoral is enabled on both sides.

2Port that will get backed up

3Link station that will get backed up

Configuring V.25bis

The following is a sample V.25bisconfiguration that could be used when APPN

traffic uses PPP over V.25bis:

Config> list device
Ifc 0 Token Ring CSR 6000000, vector 28
Ifc 1 WAN PPP CSR 81620, CSR2 80D00, vector 93
Ifc 2 WAN V.25bis CSR 81640, CSR2 80E00, vector 92
Config>set data v25 2.
Config>list device
Ifc 0 Token Ring CSR 6000000, vector 28
APPN
60 MRS V3.2 Protocol Config Ref Vol2