
Table30. Configuration Parameter List - Connection Network - Detail (continued)
Parameter Information
Parameter
BAN destination address (BDA)
ValidValues
X’0000 0000 0000’ to X’7FFF FFFF FFFF’
Default Value
X’0000 0000 0000’
Description
This parameter specifies the BAN destination address configured in the node that is
performing the BAN function. If you are using bridging to connect the LAN network to
the frame relay network, specify X’0000 0000 0000’ as the value of this parameter.In
this case, the MAC address reported to theAPPN topology for the connection network
TG is the BNI MAC address coded on theAPPN port associated with this connection
network definition.
Table31. Configuration Parameter List - Connection Network Configuration for ATM
Parameter Information
Parameter
Port name (required)
ValidValues
Name of port on whichAPPN routing has been enabled.
Default Value
None
Description
This parameter specifies the name of a port providing connectivity to the shared access
transport facility (SATF)for the connection network being defined.
All ports defined for a given connection network must be the same type and have the
same characteristics.
Parameter
fully-qualified connection network name
ValidValues
Astring of 3 to 17 characters in the form of
netID.CNname
, where:
v
netID
is a network ID from 1 to 8 characters
v
CNname
is a connection network name from 1 to 8 characters
Each name must conform to the following rules:
vFirst character:A to Z
vSecond to eighth characters:A to Z, 0 to 9
Default Value
None
Description
This parameter specifies the fully-qualified CN name to which this TG is defined.
APPN Configuration Commands
176 MRS V3.2 Protocol Config Ref Vol2