
This option lets you select the sequence of the drives on which the system searches for a valid boot record when you turn it on.
The default startup sequence is the first diskette drive followed by the first hard disk. You can alter this sequence with this utility. Figure 47 shows an example of the startup sequence when one hard disk is installed.
|
|
| |
| Set Startup Sequence |
| |
|
|
| |
| Startup Number | Device |
|
1 | .[2.88Mb | ] | |
2 | .[SCSI ROM device slot 1 bus 0 (ID,LUN).. | 6,0] | |
3 | .[Hard disk drive 0 | ] | |
4 | .[Not selected | ] |
F1=Help F3=Exit F5=Previous F6=Next F10=Save | |
| |
Figure 47. Set Startup Sequence Screen |
To change the startup sequence, move the cursor to the device box and use the F5 and F6 keys to toggle the options. The devices that you can choose will be determined by the number of devices that you have installed. A maximum of four devices may be selected in the startup sequence.
6. Set fast startup mode
If enabled, the server runs a less extensive POST routine at cold boot time, thereby reducing the amount of startup time required by the system prior to loading the operating system.
Note
You will save some startup time in this mode. However, in the unlikely event of a memory failure, you might not be aware of it until you begin using your operating system.
7.Set power on features
This panel lets you set the options for when and how the server can be started. It can be turned on automatically at a set time, or be turned on from a remote location through a modem.
When you select this option from Set Features menu, a screen like the one in