Enter password

If you enter the wrong password, the following message appears on the screen, and you are prompted again:

Incorrect password

After 3 incorrect attempts, the following message appears and you must turn off the server and start again:

System disabled

Notes:

1.Before you set a supervisor password, you must first set your selectable drive-startup sequence.

2.Only the supervisor can change the supervisor password.

3.The set user password can be selected only if a supervisor password has been created.

4.The option for fixed disk boot sector is available only with supervisor privilege level.

5.If the supervisor password is removed, the user password is also removed.

Attention!

If a supervisor password is forgotten, it cannot be overridden or removed. If you forget your supervisor password, you must have the system board replaced to regain access to your server.

Password on boot: This option allows you to enable/disable the password on boot.

It must be enabled to have the user password operational.

Diskette access rights: This option may be set to:

Supervisor, if access is only allowed to the supervisor User, if access is allowed to both supervisor and user

The supervisor password must be set for this feature to be enabled.

Fixed disk boot sector: This option may be set to:

Normal Write protect

As a form of virus protection, if this option is enabled, the boot sector of the hard drive is write-protected.

72NetWare Integration Guide

Page 86
Image 86
IBM SG24-4576-00 manual Enter password