
Figure 81. NetWare Installation
6.Select Install new NetWare 3.12 and then press Enter.
7.Select Retain Current Disk Partition and then press Enter.
8.Enter a server name and the press Enter.
9.Enter an IPX internal network number or accept the default and then press Enter.
Note
An IPX internal network number is a number used to identify the server from any other server on the network. The IPX internal network number must be different than the network number used for the LAN adapter card.
10.Specify to which directory the boot files will be installed or accept the directory default. The default is SERVER.312. Press Enter.
11.The system will prompt you for the SYSTEM_1 diskette; insert it into the diskette drive and press Enter.
12.The system will prompt you for the SYSTEM_2 diskette; insert it into the diskette drive and press Enter.
13.The system will prompt you for the UNICODE diskette; insert it into the diskette drive and press Enter.
14.Select country code, code page, and keyboard mappings and then press Enter.
15.Select a filename format and then press Enter.
16.Set up any special startup set commands (optional).
Use this to enter any specific set commands which might be required for the LAN or DISK drivers upon server startup. Most adapters will work with the defaults to get you up and running. See the documentation that came with your LAN adapter if you are not sure.
17.Assign AUTOEXEC.BAT to load SERVER.EXE.
Chapter 4. Novell NetWare Installation 129