the programmed HomeLink® button - releasing when the device begins to activate.

5.If the indicator light on HomeLink®

blinks rapidly for two seconds and then turns solid, HomeLink® has picked up a rolling codegarage door opener signal. You will need to proceed with the next steps to train HomeLink®, completing the programming may re- quire a ladder and another person for convenience.

6.Push and release the program button located on the garage door openers motor to activate the training mode. This button is usually located near the antenna wire that hangs down from the motor. If the wire originates from under a light lens, you will need to remove the lens to access the training button.

NOTE:

Once you have pushed and released the training button on the garage door openers motor and the training lightis lit, you have 30 seconds in which to perform step 7. For convenience, use the help of a second person to assist when performing this step.

7.Quickly (within 30 seconds of pushing and releasing the garage door opener

training button) and firmly push and release the HomeLink® button youve just programmed. Push and release the HomeLink® button up to three times to complete the training.

8.Your HomeLink® button should now be

programmed. To program the remaining HomeLink® buttons for additional door or gate openers, follow steps 2 through 8 only.

NOTE:

Do not repeat step 1 unless you want to

clearall previously programmed HomeLink® buttons.

If you have any questions or are having difficulty programming your HomeLink® buttons, please refer to the HomeLink® web site at: www.homelink.com or call 1- 800-355-3515.

PROGRAMMING HomeLink® FOR CANADIAN CUSTOMERS

Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your hand- held transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under Programming HomeLink®) while you push and re-push (cycle) your hand-held transmitter every

2 seconds until the indicator light flashes rapidly (indicating successful program- ming).

NOTE:

If programming a garage door opener, etc., it is advised to unplug the device during the cyclingprocess to prevent possible damage to the garage door opener com- ponents.

OPERATING THE HomeLink® UNI-

VERSAL TRANSCEIVER

HomeLink® Universal Transceiver (once programmed) may now be used to activate the garage door, etc. To operate, simply push the appropriate programmed HomeLink® Universal Transceiver button. The red indicator light will illuminate while the signal is being transmitted.

PROGRAMMING TROUBLE-DIAGNO- SIS

If HomeLink® does not quickly learn the hand-held transmitter information:

.replace the hand-held transmitter bat- teries with new batteries.

.position the hand-held transmitter with its battery area facing away from the HomeLink® surface.

Instruments and controls 2-67

Page 137
Image 137
Infiniti S51-D owner manual Programming HomeLink for Canadian Customers, Operating the HomeLink UNI, Versal Transceiver