under the following conditions:

.The ignition switch is in the ON posi- tion.

.The selector lever is in the P (Park) position.

If the outside mirrors or the steering wheel reaches its maximum adjustment, the function is automatically disabled. Restart the function by selecting a previously stored seat memory position using the memory switches (1 or 2). An Intelligent Key that was previously linked to the stored seat memory can also be used to restart the function.

If a seat position was not previously stored in the seat memory, restart the function by adjusting the steering wheel and outside mirrors manually for your best driving position and then drive the vehicle above 4 MPH (7 km/h).

Cancel or activate seat synchroni- zation function

The selector lever must be in the P (Park) position with the ignition switch in the ACC position.

The seat synchronization function can be activated or canceled by pushing and holding the SET switch for more than 10

3-26Pre-driving checks and adjustments

seconds while the ignition switch is in the ACC position.

The indicator lights on the memory switches (1 and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. Note that the indicator lights may illuminate after 5 seconds while holding the SET switch. This indicates readiness for linking the Intelligent Key to a stored memory position. Keep the SET switch pushed for more than 10 seconds to turn on or off the seat synchronization function.

MEMORY STORAGE

Two positions for the drivers seat, steering column and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the mem- ory system.

1.Move the selector lever to the P (Park) position.

2.Push the ignition switch to the ON position.

3.Adjust the drivers seat, steering col- umn and outside mirrors to the desired positions by manually operating each adjusting switch. For additional infor- mation, see SEATSin the 1. Safety

Seats, seat belts and supplemental restraint systemsection and TILTING TELESCOPIC STEERING COLUMNearlier in this section and OUTSIDE MIR- RORSearlier in this section.

4.Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second.

The indicator light for the pushed memory switch will stay on for approxi- mately 5 seconds after pushing the switch.

If memory is stored in the same memory switch, the previous memory will be deleted.

Linking Intelligent Key to a stored memory position

The Intelligent Key can be linked to a stored memory position with the following procedure.

1.Follow the steps for storing a memory position.

2.While the indicator light for the memory switch being set is illuminated for 5

seconds, push the button on the Intelligent Key. If the indicator light blinks, the Intelligent Key is linked to that memory setting.

Page 164
Image 164
Infiniti S51-D owner manual Cancel or activate seat synchroni- zation function, Memory Storage