Infiniti S51-D Clearing the Programmed IN- Formation, Reprogramming a Single HomeLink Button

.push and hold both the HomeLink® and hand-held transmitter buttons without interruption.

.position the hand-held transmitter 2 to

5 in (50 to 127 mm) away from the HomeLink® surface. Hold the transmit-

ter in that position for up to 15 seconds. If HomeLink® is not pro- grammed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times.

If you continue to have programming difficulties, please contact the INFINITI Consumer Affairs Department. The phone numbers are located in the Foreword of this Owner’s Manual.

CLEARING THE PROGRAMMED IN- FORMATION

Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds).

REPROGRAMMING A SINGLE HomeLink® BUTTON

To reprogram a HomeLink® Universal Trans- ceiver button, complete the following.

2-68Instruments and controls

1.Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed.

2.When the indicator light begins to flash slowly (after 20 seconds), position the

hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface.

3.Push and hold the hand-held transmit- ter button.

4.The HomeLink® indicator light will flash, first slowly and then rapidly. When the indicator light begins to flash rapidly, release both buttons.

The HomeLink® Universal Transceiver but- ton has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just pro- grammed. This procedure will not affect any other programmed HomeLink® buttons.

IF YOUR VEHICLE IS STOLEN

If your vehicle is stolen, you should change the codes of any non-rolling code device t h a t h a s b e e n p r o g r a m m e d i n t o HomeLink®. Consult the Owner’s Manual of each device or call the manufacturer or dealer of those devices for additional information.

When your vehicle is recovered, you will need to reprogram the HomeLink® Univer- sal Transceiver with your new transmitter information.

FCC Notice:

This device complies with FCC rules part

15.Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference that may be received, including interference that may cause undesired operation.

The transmitter has been tested and complies with FCC and DOC/MDC rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the device.

DOC: ISTC 1763K1313

FCC I.D.: CB2V67690