power using jumper cables before pushing the ignition switch and disen- gaging the steering lock.

CAUTION

.Always connect positive (+) to positive

(+) and negative () to body ground (as illustrated) not to the battery.

.Make sure the jumper cables do not touch moving parts in the engine compartment and that clamps do not contact any other metal.

6.Start the engine of the booster vehicle *A and let it run for a few minutes.

7.Keep the engine speed of the booster vehicle *A at about 2,000 rpm, and start the engine of the vehicle being jump started *B .

CAUTION

Do not keep the starter motor engaged for more than 10 seconds. If the engine does not start right away, push the ignition switch to the OFF position and wait 10 seconds before trying again.

disconnect the negative cable and then the positive cable (*4 ? *3 ? *2 ? *1 ).

9.Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes as it may be contaminated with corrosive acid.

10.Put the battery cover on.

PUSH STARTING

Do not attempt to start the engine by pushing.

CAUTION

.Automatic transmission models cannot be push-started or tow-started. Attempt- ing to do so may cause transmission damage.

.Three way catalyst equipped models should not be started by pushing since the three way catalyst may be damaged.

.Never try to start the vehicle by towing it; when the engine starts, the forward surge could cause the vehicle to collide with the tow vehicle.

If needed, Roadside Assistance is avail- able. Please see your Warranty Information Booklet or Roadside Assistance I.D. Card for the toll-free number to call (U.S.) or Warranty & Roadside Assistance Informa- tion Booklet (Canada).

8. After starting your engine, carefully

In case of emergency 6-9

Page 394
Image 394
Infiniti S51-D owner manual Push Starting, Do not attempt to start the engine by pushing