Infiniti S51-D Confirming memory storage, Selecting the memorized position, System Operation

Push the ignition switch to the OFF posi-

tion, and then push the button on the Intelligent Key. The driver’s seat, steering wheel and outside mirrors will move to the memorized position or to the exit position when the entry/exit function is set to active.

Confirming memory storage

.Push the ignition switch to the ON position and push the SET switch. If the main memory has not been stored, the indicator light will come on for approxi- mately 0.5 second. When the memory has stored in position, the indicator light will stay on for approximately 5 seconds.

.If the battery cable is disconnected, or if the fuse opens, the memory will be canceled. In this case, reset the desired position using the previous procedure.

.If optional Intelligent Keys are added to your vehicle, the memory storage pro- cedure to switch 1 or 2 and linking Intelligent Key procedure to a stored memory position should be performed again for each Intelligent Key. For additional Intelligent Key information, see “KEYS” earlier in this section.

Selecting the memorized position

1.Move the selector lever to the P (Park) position.

2.Use one of the following methods to move the driver’s seat, the outside mirrors and the steering wheel.

. Push the ignition switch to the ON position and push the memory switch (1 or 2) fully for at least 1 second.

. Within 45 seconds of opening the driver’s door, push the memory switch (1 or 2) fully for at least 1 second.

The driver’s seat, steering column and outside mirrors will move to the mem- orized position or to the exit position when the entry/exit function is set to active with the indicator light flashing, and then the light will stay on for approximately 5 seconds.

SYSTEM OPERATION

The automatic drive positioner system will not work or will stop operating under the following conditions:

.When the vehicle speed is above 4 MPH (7 km/h).

.When the adjusting switch for the driver’s seat and steering column is turned on while the automatic drive positioner is operating.

.When the memory switch 1 or 2 is not pushed for at least 1 second.

.When the seat, steering column and outside mirrors have already been moved to the memorized position.

.When no position is stored in the memory switch.

.When the engine is started while moving the automatic drive positioner.

.When the AT selector lever is moved from the P (Park) position to any other position. (However, it will not be canceled if the switch is pushed while the seat and steering column are returning to the previous positions (entry/exit function).)

.When the driver’s door remains open for more than 45 seconds and the ignition switch is not in the ON posi- tion.

.The seat synchronization function is automatically disabled if the outside mirrors or steering wheel reaches its maximum adjustment.

Pre-driving checks and adjustments 3-27