For all-wheel drive

If you install snow tires, they must also be the same size, brand, construction and tread pattern on all four wheels.

SPECIAL WINTER EQUIPMENT

It is recommended that the following items be carried in the vehicle during winter:

.A scraper and stiff-bristled brush to remove ice and snow from the windows and wiper blades.

.A sturdy, flat board to be placed under the jack to give it firm support.

.A shovel to dig the vehicle out of snowdrifts.

.Extra window washer fluid to refill the reservoir tank.

DRIVING ON SNOW OR ICE

WARNING

.Wet ice (328F, 08C and freezing rain), very cold snow or ice can be slick and very hard to drive on. The vehicle will have much less traction or gripunder these conditions. Try to avoid driving on wet ice until the road is salted or

5-80Starting and driving

sanded.

.Whatever the condition, drive with cau- tion. Accelerate and slow down with care. If accelerating or downshifting too fast, the drive wheels will lose even more traction.

.Allow more stopping distance under these conditions. Braking should be started sooner than on dry pavement.

.Allow greater following distances on slippery roads.

. Watch for slippery spots (glare ice). These may appear on an otherwise clear road in shaded areas. If a patch of ice is seen ahead, brake before reaching it. Try not to brake while on the ice, and avoid any sudden steering maneuvers.

.Do not use the cruise control on slippery roads.

.Snow can trap dangerous exhaust gases under your vehicle. Keep snow clear of the exhaust pipe and from around your vehicle.

ENGINE BLOCK HEATER (if so equipped)

Engine block heaters are available through INFINITI dealers to assist in cold tempera- ture starting. The engine block heater should be used when the outside tempera- ture is 208F (78C) or lower.

To use the engine block heater

1.Turn the engine off.

2.Open the hood and unwrap the engine block heater cord.

3.Plug the engine block heater cord into a grounded 3-wire, 3-pronged extension cord.

4.Plug the extension cord into a Ground Fault Interrupt (GFI) protected, grounded 110-volt AC (VAC) outlet.

5.The engine block heater must be plugged in for at least 2 - 4 hours, depending on outside temperatures, to properly warm the engine coolant. Use an appropriate timer to turn the engine block heater on.

6.Before starting the engine, unplug and properly store the cord to keep it away from moving parts.

Page 383
Image 383
Infiniti S51-D For all-wheel drive, Special Winter Equipment, Driving on Snow or ICE, Engine Block Heater if so equipped