Intermec 6710 manual Status Mode, Error Status

SECTION 6 " Indicator Lights

STATUS

The STATUS (left) light indicates the access point’s operating status. When the light is OFF, the access point is operating normally. When the light is ON, it is in error mode.

"NOTE: In certain cases the following text refers to the indicator lights by number. Lights are numbered from left to right. Light 1 is labeled LINK and Light 8 is labeled NIC2.

The access point enters error mode when it detects a malfunction during the power-on self tests or when certain hardware malfunctions occur during normal operation. When the STATUS light is ON to indicate the error mode, indicator lights 4 through 8 (the STATUS MODE light and the NETWORK and PCMCIA light pairs) display a binary error status code between 1 and 31. This code indicates the specific condition causing the error status as shown in Table 6-2. Descriptions of errors are on page 6-4.

Table 6-2

Error Mode Status Codes

Status	Mode	R-LINK	W-LINK	NIC1	NIC2	Error Status
ON	OFF	OFF	OFF	OFF	ON	Hardware error 1.
ON	OFF	OFF	OFF	ON	OFF	Hardware error 2.
ON	OFF	OFF	OFF	ON	ON	Hardware error 3.
ON	OFF	OFF	ON	OFF	OFF	Internal serial loop-
						back test failed.
ON	OFF	OFF	ON	OFF	ON	Internal MACE AUI
						loopback test failed.
ON	OFF	OFF	ON	ON	OFF	Internal 10BASE-T
						loopback test failed.
ON	OFF	OFF	ON	ON	ON	Timer test failed.

6710 Access Point User’s Guide 6-3