Intermec 6710 manual Tftp Client Command Retry, Reboot Command, Is the same as

SECTION 5 " Software Download

In addition, all commands are case insensitive, so:

FILE FE ID:

is the same as:

file fe id:

TFTP Client Command Retry

When executing a script file, the access point retries TFTP client commands GET and PUT until the command completes successfully. If the first attempt to transfer the file fails, the access point retries after a one-minute delay. With each successive failure, the retry time doubles until it reaches 8 minutes. Once this limit is reached, it remains at 8 minutes until the command completes.

Reboot Command

The Reboot command (located on the Main Menu) forces the access point to restart immediately. If it is issued within a script file, commands following it are not executed. If used, Reboot should always be the last command in the file.

Because Reboot causes an immediate reboot before the script file processing is completed, the software download status is not updated to accurately reflect the result of the software download. While this has no adverse effect on access point operation, you can not tell whether the download completed successfully without examining the version numbers of the active boot and data files after the access point has rebooted.

The preferred method of rebooting after a script file has completed is to set the next power up time variable. This should be the last thing the script file does, to allow the script file processing to complete and the software download status variable to be updated before the reboot occurs.

5-166710 Access Point User’s Guide