Intermec 6710 manual Power-Up Sequence

SECTION 6 " Indicator Lights

Power-Up Sequence

When you power on the access point, it performs a power-up sequence that does the following:

"Tests the indicator lights.

"Tests the functional circuits.

"Determines the operational status.

"Determines the boot sequence.

You can monitor the power-up sequence through the indicator lights. During power-up the lights operate in this order:

1.LINK indicator light turns ON and stays ON.

2.STATUS, MODE, R-LINK, W-LINK, NIC1, and NIC2 lights blink three times to indicate they are operational.

3.After the previous lights stop blinking, W-LINK light blinks three more times.

4.About eight seconds after W-LINK stops blinking, R-WINK, W-LINK, NIC1 and NIC2 lights either turn ON or stay OFF to indicate the DIAG port’s baud rate (see page 6-6).

5.MODE light blinks constantly to indicate it is in network mode, the normal operating condition.

After the access point completes its boot sequence, it enters its normal operating mode. During normal operation the STATUS indicator light is OFF.

6710 Access Point User’s Guide 6-7