Intermec 6710 manual Mode, Error Status Description

SECTION 6 " Indicator Lights

"NOTE: Contact the Customer Response Center for help with the following.

Error Status Description

Hardware errors 1, 2, and 3

These errors indicate an internal hard- ware error or malfunction. The errors can occur when you apply power to the access point. If it encounters a hardware error, it no longer functions.

Internal serial loop-	This failure occurs if the access point
back test failed	does not successfully complete the
	power-on self-test. The error indicates a
	probable hardware malfunction
	associated with the DIAG port. In most
	cases, the unit continues to operate nor-
	mally, but the error condition still exists.
Internal MACE	This failure occurs if the access point
(Media Access Con-	does not successfully complete the
troller for Ethernet)	power-on self-test. The error indicates a
AUI loopback test	probable hardware malfunction
failed	associated with the AUI port. In most
	cases the unit continues to operate nor-
	mally, but the error condition still exists.
Internal 10BASE-T	This failure occurs if the access point
loopback test failed	does not successfully complete the
	power-on self-test. The error indicates a
	probable hardware malfunction
	associated with the 10BASE-T port. In
	most cases the unit continues to operate
	normally, but the error condition still
	exists.
Timer test failed	This failure occurs when the access point
	timer circuit malfunctions. If a timer er-
	ror occurs, the unit no longer functions.

MODE

The right STATUS light is labeled MODE. It indicates the current status of the access point (Table 6-3).

6-46710 Access Point User’s Guide