20
RE
COR
DIN
G (Cont.)
Recording From The Middle Of A Tape
When removing a tape on which you were recording, or when you resume recording on a tape after playing back the recording previously made (without taking the tape out between recordings), perform this procedure.
LCD monitor
STOP PLAY REW FF
PLAY/PAUSE REW FF
STOP
EC 5 | |
R | S |
OFF |
|
Y |
|
A |
|
L |
|
P | Lock button | |
| ||
|
| RECORDING |
Power Dial | START/STOP Button | |
| S |
|
C | 5 |
|
|
| |
E |
|
|
R |
| |
OFF |
| |
| Y |
|
| ALP |
|
1 OPEN LCD MONITOR
Make sure the LCD monitor is open fully.
2 SELECT MODE
Press down the lock button located on the Power Dial and turn the Power Dial to "PLAY".
3 START SEARCH
Press PLAY/PAUSE, then press REW or FF. Watch in the LCD monitor for the spot where you want to begin recording.
4 ENGAGE STILL MODE
Once you find the spot at which you want to start recording, press PLAY/PAUSE to engage the Still mode.
5 START RECORDING
Set the Power Dial to “REC” and press
RECORDING START/STOP.
•Start recording from a point prior to the end of the last recording. A few seconds of the end of the last recording will be erased.
NOTE:
If you start recording from the end of the previous recording leaving no blank space, there may be situations where a clean transition is not possible.
