
NOTES:
●If you connect the camcorder’s DC cord to the adapter during battery charging, power is supplied to the camcorder and charging stops.
●When using the AC Power Adapter/Charger, be sure to use the supplied power cord only.
●The AC Power Adapter/Charger is for use with the
●When charging the Battery Pack for the first time or after a long storage period, the Charge Indicator may not light. In this case, remove the Battery Pack from the AC Power Adapter/Charger, then try charging again.
●Since the AC Power Adapter/Charger processes electricity internally, it becomes warm during use. Be sure to use it only in
** Charging Environment
Perform charging where the temperature is between 10° and 30°C.
Continuous Shooting
Continuous shooting is possible for approximately
60 minutes, under the following conditions:
•A
•The temperature is approximately 20°C/68°F
However, . . .
•If the temperature is below 10°C/50°F, or
•If zoom or Record/Standby are engaged repeat- edly, continuous shooting capability is reduced significantly. Before extended use, it is recom- mended that you prepare enough battery packs to cover 3 times the planned shooting time.
9
Installing The Battery Pack
The battery pack does not charge while in the camcorder. Before installation, make sure the battery pack has been charged fully.
Battery cover
Open switch
1
2
Battery
1 OPEN BATTERY COVER
1 Slide the open switch on the battery cover.
2 Pull open the battery cover in the direction of the arrow.
2 INSERT BATTERY
Insert the + – end of the battery first.
CLOSE BATTERY COVER | |
3 Slide the open switch and close the battery | |
cover. |
|
BATTERY | RECORDING TIME |
approx. 60 min. |
NOTES:
●To remove the battery pack, turn the Power Dial to "OFF", open the battery cover and slide the battery pack out.
●Be careful not to drop the battery pack.