Masterpage:Right0

EN 13

Filename [XVC33UM_06Index.fm]
Page 13 9 September 2003 9:26 am

INSTALLING YOUR NEW UNIT

Basic Connections
It’s essential that your unit be properly connected.
ACheck the contents.
Make sure the package contains all of the accessories
listed in “SPECIFICATIONS” on page89.
BSituate the unit.
Place the unit on a stable, horizontal surface.
CConnect the unit to TV.
The connection method you use depends on the type of
TV you have.
RF Connection
8To connect to a TV with NO AV input connectors —
ADisconnect the TV antenna from the TV.
BConnect the TV antenna cable to the VHF/UHF IN
connector on the rear panel of the unit.
CConnect the supplied RF cable between the VHF/UHF
OUT connector on the rear panel of the unit and the
TV’s antenna terminal.
AV Co nnect ion
8To connect to a TV with AV input connectors—
AConnect the antenna, unit and TV as per “RF
Connection”.
BConnect an optional audio/video cable between the
AUDIO/VIDEO OUTPUT connectors on the rear
panel of the unit and the TV’s audio/video input
connectors.
●Set your TV to AV mode.
●For switching the TV’s mode, refer to the instruction manual of
your television.
●To obtain high-quality pictures, you can also use the S-VIDEO
connection or Component Video Connection. (DVD deck
only) (墌pg. 14, 15)
DConnect the unit to power source.
Plug the end of the AC power cord into an AC outlet.
ESet the VCR channel.
The VCR channel is the channel on which you can watch
the picture from the unit on the TV when only using RF
connection.
With RF connection, set the VCR channel to “3 CH” or “4
CH”.
●The VCR channel is preset to “3 CH”. Set to “4 CH” if the
Channel 3 is used for broadcasting in your area.
With AV connection, set the VCR channel to “–CH” (off).
To set the VCR channel, perform the following steps:
AWhen the unit is turned off, press STOP (8) on the unit
for more than 5 seconds. “3 CH” appears on the front
display panel.
BPress CH +/– on the Remote to select “3 CH”, “4 CH”
or “– CH” (off), then press OK.
●If Plug&Play or Tuner setting has not previously been
performed, the Language Select screen appears and Plug&Play
takes place automatically.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
COAXIALOPTICAL
PCM/STREAM
Antenna or Cable
Matching transformer
(not supplied)
Coaxial cable
VHF/UHF OUT
VIDEO OUTPUT
AC Outlet
RF cable
(supplied)
Back of unit VHF/UHF
IN
AUDIO
OUTPUT
Audio/video cable
(not supplied)
Flat feeder
TV
AC Power Cor d
To 75 ohm
Term inal
To Audio/video
input connectors
Before performing the following steps:
●Make sure there is no cassette inserted in the unit.
●Make sure the unit is turned on, then press VCR/
DVD on the unit or VCR on the Remote so that the
VCR indicator lights up.
XVC33UM_06Index.fm Page 13 Tuesday, September 9, 2003 9:27 AM