JVC HR-XVC33UM manual Picture Settings, Audio Settings

Filename [XVC33UM_10Subsidiary.fm]
XVC33UM_01.book Page 79 Monday, August 4, 2003 7:24 PM	Masterpage:Right-No-Heading

EN 79

Picture Settings

* The default setting is bold in the table below.

8 MONITOR TYPE	You can select the monitor type depending the TV used when you play back
16:9 NORMAL	DVD VIDEO discs recorded for wide-screen TVs. For more details, refer to
16:9 AUTO	“Monitor Set (DVD deck)” ( pg. 18)
4:3 LB
4:3 PS
8 PICTURE SOURCE	You can obtain optimal picture quality by selecting whether the content on the
VIDEO (NORMAL)	disc is processed by field (video source) or by frame (film source).
VIDEO (ACTIVE)	Normally set to “AUTO”.
FILM	VIDEO (NORMAL):
AUTO		Suitable for playing back a video source disc with relatively a
		few moments.
	VIDEO (ACTIVE):
		Suitable for playing back a video source disc with relatively a
	FILM:	lot of movements.
		Suitable for playing back a film or progressive source disc.
	AUTO:	Used to play back a disc containing both video and film
		source materials. This unit recognizes the picture type (film or
		video source) of the current disc according to the disc
		information.
	● If the playback picture is unclear or noisy, or the oblique lines of the picture
	are rough, try to change to other modes.
8 SCREEN SAVER	The TV screen may be burned out if a static picture is displayed for a long time.
ON	When this function is set to “ON”, the unit automatically activates the screen
OFF	saver function if a static picture, such as an on-screen display or menu is
	displayed for over 5 minutes.
	NOTE:
	This function is not available for Audio CDs and MP3 discs.
8 MP3/JPEG	You can select files to play back, when both MP3 files and JPEG files are
MP3	recorded on a disc.
JPEG	MP3:	Select this to play back MP3 files.
	JPEG:	Select this to play back JPEG files.
	NOTE:
	You cannot access the DVD Set Up screen and “X” appears on the TV screen if a disc is
	already placed.

Audio Settings

* The default setting is bold in the table below.

8 DIGITAL AUDIO OUTPUT	Set to the appropriate mode according to the type of the device connected to
PCM ONLY	DIGITAL AUDIO OUT connector on the rear of unit.
DOLBY DIGITAL/PCM	It is not necessary to set this mode when you connect no device to DIGITAL
STREAM/PCM	AUDIO OUTconnector.
	PCM ONLY:
	Select this when you connect the unit’s DIGITAL AUDIO OUT
	connector to the linear PCM digital input connector of other audio
	device.
	DOLBY DIGITAL/PCM:
	Select this when you connect the unit’s DIGITAL AUDIO OUT
	connector to the digital input connector of a Dolby Digital decoder
	or an amplifier with a built-in Dolby Digital decoder.
	STREAM/PCM:
	Select this when you connect the unit’s DIGITAL AUDIO OUT
	connector to the digital input connector of an amplifier with a built-
	in DTS, Dolby Digital, or MPEG multichannel decoder.

Page 79

4 August 2003 6:42 pm