JVC HR-XVC33UM manual 74 EN, Make connections, Back of unit

Filename [XVC33UM_09Editing.fm]
XVC33UM_01.book Page 74 Monday, August 4, 2003 7:24 PM	Masterpage:Left+

74 EN REMOTE (cont.)

Connecting To A Dolby Digital Decoder or An Amplifier With A Built-in DTS

(DVD deck only)

These instructions enable you to connect your unit to dolby digital decoder or amplifier with a built-in DTS.

DIGITAL AUDIO OUT

Back of unit

Dolby Digital decoder or

To DIGITAL AUDIO amplifier with a built-in DTS input

Optical cable (not supplied)

Note for connection:

Remove the connector cover from the unit and remove the protection cap from the cable.

Make connections.

Connect the optical cable between the unit and the Dolby Digital decoder or amplifier with a built-in DTS.

NOTES:

●For Dolby digital sound, set “DIGITAL AUDIO OUTPUT” to “DOLBY DIGITAL/PCM”. ( pg. 79)

●For DTS sound, set “DIGITAL AUDIO OUTPUT” to “STREAM/ PCM”. ( pg. 79)

CAUTIONS:

●This unit has a dynamic range of more than 80 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

●Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the video playback picture.

Page 74

4 August 2003 6:50 pm