JVC HR-XVC33UM manual 76 EN, For Example

Filename [XVC33UM_10Subsidiary.fm]
XVC33UM_01.book Page 76 Monday, August 4, 2003 7:24 PM	Masterpage:Left+

76 EN			SUBSIDIARY SETTINGS (cont.)
			* The default setting is bold in the table below.
8 PICTURE CONTROL	This feature helps you to adjust the playback picture quality according to your
NORM	preference. Normally select “NORM”.
EDIT	NORM:	Picture quality is adjusted automatically.
SOFT	EDIT:	Minimizes picture degradation during editing (recording and playback).
SHARP
	SOFT:	Reduces image coarseness when viewing overplayed tapes containing a
		lot of noise.
	SHARP	Clearer, sharper-edged picture when viewing images with lots of flat,
		same-coloured surfaces such as cartoons.
	NOTES:
	● When you select “EDIT”, “SOFT” or “SHARP”, the selected mode will not change until you
	select another mode.
	● When you select “EDIT” to dub tapes, be sure to select “NORM” after you finish dubbing
	the tapes.
8 SUPERIMPOSE	When this function is set to “ON”, various operational indicators appear on the TV
ON	screen. Messages appear in the selected language. ( pg. 20)
OFF	NOTES:
	● When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE” to
	“OFF” before starting.
	● During playback, the operation mode indicators may be disturbed depending on the type of
	tape being used.
8 AUTO SP]EP TIMER	When this function is set to “ON”, the unit automatically switches to EP mode to
ON	allow complete recording if there is not enough tape to record the entire program
OFF	while timer-recording in SP mode.
	For Example:
	Recording a program of 140 minutes in length onto a 120-minute tape
	Approximately 110 minutes		Approximately 30 minutes
	SP mode		EP mode
		Total 140	minutes
	Make sure you set this function to “ON”, before the timer-recording starts.
	NOTES:
	● If you have programed the unit to timer-record 2 or more programs, the second program
	and those thereafter may not fit on the tape if you set “AUTO SP]EP TIMER” to “ON”. In
	this case, make sure the mode is not engaged, then set the tape speed manually during
	timer programing.
	● In order to ensure that the recording fits on the tape, this feature may leave a slight non-
	recorded section at the end of the tape.
	● There may be some noise and sound disturbance at the point on the tape where the unit
	switches from SP to EP mode.
	● The Auto SP]EP Timer feature is not available during ITR (Instant Timer Recording), and
	the feature will not work properly on the following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and
	T(ST)-120

Page 76

4 August 2003 6:42 pm