JVC HR-XVC33UM manual 86 EN

Filename [XVC33UM_11Trouble.fm]
XVC33UM_01.book Page 86 Monday, August 4, 2003 7:24 PM	Masterpage:Left+

86 EN			TROUBLESHOOTING (cont.)
TIMER RECORDING (VCR deck)
	SYMPTOM	POSSIBLE CAUSE	CORRECTIVE ACTION
1.	Timer recording won’t work.	● The clock and/or the timer have been set	Re-perform the clock and/or timer
		incorrectly.	settings.
		● The timer is not engaged.	Press TIMER and confirm that “#” is
			displayed on the front display panel.
2.	Timer programing is not possible.	● Timer recording is in progress.	Timer programing can’t be performed
			while a timer recording is in progress.
			Wait until it finishes.
3.	“#” on the front display panel won’t	● The timer is engaged but there’s no	Load a cassette with the record safety tab
	stop blinking.	cassette loaded.	intact.
4.	“#”, “” and “$” on the front	● The loaded cassette has had its record	Remove the cassette and cover the hole
	display panel won’t stop blinking.	safety tab removed.	with adhesive tape, or insert a cassette
			with the record safety tab intact.
		● The end of the tape was reached during	The program may not have been recorded
		timer recording.	in its entirety. Next time make sure you
			have enough time on the tape to record
			the entire program.
5.	“#” blinks for 10 seconds and the	● TIMER has been pressed when there are	Check the programed data and re-
	Timer mode is disengaged.	no programs in memory, or the timer	program as necessary, then press TIMER
		record information has been programed	again.
		incorrectly.
6.	“” and “$” on the front display	● The end of the tape was reached during	The program may not have been recorded
	panel won’t stop blinking.	Instant Timer Recording.	in its entirety. Next time make sure you
			have enough time on the tape to record
			the entire program.
7.	“N”, “” and “$” on the front display	● The loaded cassette has had its record	Remove the cassette and cover the hole
	panel won’t stop blinking.	safety tab removed.	with adhesive tape, or insert a cassette
			with the record safety tab intact.
		● The end of the tape was reached during	The program may not have been recorded
		Satellite Auto Recording.	in its entirety. Next time make sure you
			have enough time on the tape to record
			the entire program.

Page 86

4 August 2003 6:50 pm