JVC LST0728-001C Memo :, Note :, Note :, Applications, PTZ Scanning, Specifying Patrol Timing, Auto PTZ Patrolling (continued)

Applications

Defining a Preset PTZ Position (continued)

Auto PTZ Patrolling (continued)Specifying Patrol Timing

1 Select the patrol scheme that you want to define from the [Patrol scheme] list

2 Specify the duration (seconds) for the PTZ camera to stop at each preset position in the [Stay at each position in the patrol schedule(in seconds)] field

3 Specify the time required for the PTZ camera to move between two preset positions in the [Time for each PTZ camera movement to complete(in seconds). Motion detection is disabled during movement.] field

[Setup PTZ Patrolling] Screen

Memo :

●In order not to generate false motion alarms, motion detection and recording are automatically disabled when the PTZ camera is moving between two preset positions. After the lapse of the specified interval, motion detection is automatically enabled again.

Note :

●It is important that the camera is able to reach all the preset positions defined in the patrolling scheme within the time interval you have specified. Otherwise, false motion may be detected.

PTZ Patrolling Actions Upon Detection of Motion1 Select the [Disable patrolling schedule if motion is detected] check box2 Select the conditions for resuming PTZ patrolling

●When a specific time interval has lapsed after the first detected motion, regardless of whether any subsequent motion is detected

●When a specific time interval has lapsed after the last detected motion

3 Specify the selected condition in units of secondsPTZ Scanning

For cameras that support PTZ scanning, you can enable this feature in the [Setup of PTZ Scanning] section to select a PTZ scanning speed.

Note :

●To define a patrol scheme, you must specify at least two preset positions. You must also specify the period for which the patrol scheme is enabled in [Camera Record Setting]-[Scheduler...].

●Patrolling of PTZ cameras may be interrupted either manually or when an event occurs. When this occurs, you need to specify the duration (seconds) before resuming patrol in [Camera Record Setting]-[General Settings]-[Patrolling Settings]. The settings in this section are applied to all PTZ cameras installed in the system. The default setting is 30 seconds.

94