Basic Operation

Switching the Power On/ Off

Switching the Power On1 Connect the power cable

●Connect using the power cable supplied to an AC100V (50 Hz/60 Hz) outlet.

2 Turn AONB the power switch at the rear panel.

●A system check will run when the power is turned on.

●The [OPERATE] indicator starts blinking.

●After blinking, the [OPERATE] indicator lights up to indicate that operation has been turned on.

●When the setting is complete, recording starts automatically in the record control mode. (When the AON at startupB checkbox of [Record Control] under [Unit Setting 1] of the main menu is selected.)

Note :

●Do not disconnect the power cord nor turn the power switch AOFFB while the system check is running or in the OPERATE ON mode. Otherwise, it may break down.

Memo :

●If the device does not start up even after the power switch on the rear panel is turned AONB, press the [OPERATE] button on the front panel.

Switching the Power Off1 Press and hold the [OPERATE] button for about2 seconds to turn off the power

●After blinking, the [OPERATE] indicator goes off.

2 Turn off the power switch on the rear panel

Note :

●The recorded images may not be played back properly if they are not archived (A Page 110) before the power failure.

●It is recommended that an uninterruptible power supply (UPS) be used to protect the hard disk from damage in the event of a power failure. (A Page 136)

●Be sure to press and hold down the [OPERATE] button on the front panel to shut down the system before switching off the power supply. Turning off the power switch on the rear panel while the device is in the OPERATE ON mode may cause malfunction.

Switching Operation On/ Off

Switching On/Off Using Operate Button on Front Panel

You can switch operation to ON or OFF.

Switching Operation On1 (When Operation is OFF) Press the [OPERATE] button

●The [OPERATE] indicator starts blinking.

●The [OPERATE] indicator lights up, indicating that operation is enabled.

Memo :

●When the power switch on the rear panel is turned on, the system starts up automatically until the OPERATE ON mode is activated.

Switching Operation Off

1 (When operation is ON) Press and hold the [OPERATE] button for about 2 seconds

●The [OPERATE] indicator starts blinking.

●The screen display disappears and the [OPERATE] indicator goes off, indicating that operation has been turned off.

Note :

●Do not turn off the power until operation has been turned off.

Switching On/Off Using Input/Output Terminal on Rear Panel

For details on the layout of the input and output terminals on the rear panel, refer to [Rear I/O Terminals] (A Page 15).

Switching Operation On

1 (When operation is OFF) Set the [OPE ON/OFF] terminal to make for at least 50 ms

●The [OPERATE] indicator starts blinking.

●The [OPERATE] indicator lights up, indicating that operation is enabled.

Switching Operation Off

1 (When operation is OFF) Set the [OPE ON/OFF] terminal to make for at least 1 s

●The [OPERATE] indicator starts blinking.

●The screen display disappears and the [OPERATE] indicator goes off, indicating that operation has been turned off.

Note :

●Do not turn off the power until operation has been turned off.

30