Applications

Flash Memory Utility (continued)

Reading Preset Data

This section describes procedures for reading the preset data from the flash memory.

1 Insert the flash memory device into the [SERIAL] terminal on the front (rear) panel

2 Select [Load Setting Data]

●If data is stored on the flash memory device, a list of data stored in the device will appear in the preset data list.

●The [Flash memory cannot be detected] message may appear in some cases. In this case, wait for about 30 seconds and select [Load Setting Data] again.

●Preset data that is stored on this unit is indicated by AMy MachineB at the beginning. Data stored on other NVR units is displayed as AOther MachineB. This is followed by a pair of parentheses, which contains the MAC address of the NVR where data was saved. This is followed by the saved date/time in the Ayyyy-mm-dd-sec-SettingBformat.

●If multiple data are displayed, highlight the data in the list that you want to read.

[Setting Data List] Screen

3 Select the setting to load, followed by pressing [Load]

●The highlighted data will be read.

4 The [Load Setting Data?] confirmation message appears. Press [OK].

●The preset data will be read.

●When reading is complete, a message informing you that data has been read appears. Click the [OK] button.

5 Press [Close] to return to the [Flash Memory Utility] screen
Removing the Flash Memory Device1 Select [Remove Flash Memory]

●The [Remove Flash Memory?] confirmation dialog appears. Press [OK].

●The [Flash Memory was removed] message appears. Press [OK].

2 Remove the flash memory device from the [SERIAL] on the front (rear) panel

Memo :

●Items specified in the [Image Quality...] settings of [Main Menu]-[Camera Record Setting] (A Page 58), [OS Setting] (A Page 73), and [Password] section of [Unit Setting 1] (A Page 69) will not be saved.

●To read the preset data after you have selected [Remove Flash Memory], remove the flash memory device from the serial terminal and insert it again. When the flash memory is inserted, it will be automatically detected.

Note :

●If you are reading preset data saved using a different language setting, change [Language Setting] of the [Main Menu] to the language used when the data is saved.

●If a Master/Slave setup is created using Milestone System’s Enterprise 6.0 on an NVR, settings on that unit cannot be loaded on another NVR.

●Data saved using VR-N900U cannot be used on VR-N1600U/E. and vice versa.

112