JVC LST0728-001C Note :, Note :, I/O Settings, 1 Click the [I/O Setup...] button on the [Camera Record Setting] screen

Camera Input/Output Port and Events

The input/output port is the input/output terminal that is found on each device registered with this unit. You can register the input port as [Input events], and the output port as [Outputs...].

A registered input/output port can be linked to an event as described below. (A Page 102 [Specifying an Output Port])

●Events can be used to start recording, send e-mails, move the PTZ camera to a preset position, and control the output port of the device. Events are divided into the four types as described below.

Input events	Registers input signals of sensors connected
	to the input port of the device as an [Input
	events].
Generic events	Registers as a generic event.
VMD events	Registers the detected image motion as a
	VMD (Video Motion Detection) event.
Event buttons	Event generated by buttons that enable
	manual operation.

I/O Settings1 Click the [I/O Setup...] button on the [Camera Record Setting] screen

●The [I/O Setup] screen appears.

●The [I/O Setup] screen enables you to add input events, VMD events and outputs that can be used by the network cameras.

AF

BE

CD

[I/O Setup] Screen

	Item		Description
A Add new		For specifying input events for the device
event...		selected in the [Defined events] list. You
		may be able to specify multiple input
		events for some devices.
		Click the [+] mark next to the device in the
		[Defined events] list, select the preset
		input event, and click the [Add new
		event...] button to specify a timer event.
		(A Page 97)
B Add new		Displays the [Add new output] screen.
output event...		(A Page 98)
C Add VMD		For specifying a VMD (Video Motion
Event(Motion		Detection) event for the device selected in
Detection)		the [Defined events] list. Only one VMD
		event can be defined for each camera.
		Note :
		● To avoid the risk of generating an
		excessive number of VMD events, a
		new VMD event cannot occur within
		five seconds after the occurrence of
		the last VMD event.
		● VMD events cannot be sent by e-mail.
D Advanced...		Displays the [Advanced...] screen.
		(A Page 98)
E Remove		For deleting the event selected in the
selected		[Defined events] list.
F Edit		For editing the event selected in the
selected...		[Defined events] list.
Note :

●The available events differ among network cameras.

●When an event is defined using the [I/O Setup] screen, this automatically overwrites the alarm settings at the camera. If a generic event is already in use (when the alarm settings at the camera are configured manually), the generic event or the event audio that makes use of the generic event (A Page 129) will be disabled. However, the generic event settings at the recorder unit remain unchanged. (VR-N1600U/E)

95