JVC LST0728-001C Memo :, Note :, Memo :,  Conditionally

	Item	Preset Values				Description
ERecording Settings (continued)
	Enable speedup	On motion		Enables you to specify whether to execute recording with a higher maximum frame rate when
		On event		motion is detected or when an event occurs.
				When [On event] is selected : Specify the starting and ending events in the [Start]
						and [Stop] fields respectively.
						The speedup recording frame rate uses the [Frame
						Rate] in the [Speedup Settings] A item.
				When the input is analog		: Values of frame rate that can be set are 30, 15, 10, 7,
						6, 5, 3, 2, and 1.
						When set to 7, the rate is 7.5 frames per second.
	When to store	Always		Always	: Select this check box to record images at all times.
	images in	Never		Never	: Do not perform recording in the recording control mode. Record
	database
		 Conditionally			starts when the [REC/STOP] button is pressed.
				Enables you to specify the recording conditions in recording control mode. If you have
				selected [Conditionally], specify the following fields as well.
				On motion	: Select this check box to record all images for which motion has been
					detected.
				On event	: Select this check box to record all images from the occurrence of an
					event until the next event occurs regardless of motion. Specify the
					starting and ending events in the [Start] and [Stop] fields
					respectively.
				Memo :
				● For details on events, refer to [Camera Input/Output Port and Events] (A Page 95).
				Note :
				● If you have selected [Conditionally], the [ALARM] indicator on the front panel lights up
				regardless of the recording status when the motion or event specified in [When to store
				images in database] occurs. Press the [ALARM CLEAR] button to turn off the light of the
				[ALARM] indicator.
				( )seconds pre/post recordings on motion/event:
				You can record images preceding and following a detected motion or event. Specify the time
				interval to record in the number of seconds before and after the occurrence. (A Page 139)
				Memo :
				● Do not set to A0 secondsB.
				● If Offline is selected in [Scheduler...], images will not be recorded.
				● This setting has no impact on manual recording, emergency recording, and [EXT REC IN]
				recording.
F Datebase		^		Enables you to specify the database settings. (A Page 110)
	Settings
G Motion		^
	Detection
	Settings
	Motion Detection..		Enables you to specify the two parameters for motion detection, namely [Sensitivity] and
				[Motion Sensitivity]. (A Page 104)
	Motion Color..		Enables you to specify the color to be used for highlighting detected motion.

57