KitchenAid KESH307H, KESC300H, KESC307H manual Ground link Screw

4-Wire Electrical Connection

1.Remove the ground-link screw from the range frame and set the screw aside.

2.Bend the ground link up so that it does not contact the range.

	ground-link
ground link	screw

3.Connect the green ground wire on the power supply cord to the ground link screw hole in the range with the ground-link screw you removed earlier. Make sure that the bare ground wire does not contact the adjacent terminal block connections.

ground-link screw

bare wire from power supply cable

NOTE: Do not loosen the factory-installed nuts on the terminal block when you perform the following steps.

4.Connect the neutral (white) wire of the power supply cord to the center, silver-

colored terminal screw on the terminal block, and secure it with one of the 3/8″ brass nuts that you set aside earlier.

5.Connect the remaining two power supply

cord wires to the outer terminals of the terminal block, and secure them with 3/8″ brass nuts.

6.Tighten the strain relief screws to secure the power supply cord.

7.Install the terminal block cover.

silver-colored terminal block screw

neutral wire (white wire)

bare wire from power

supply cable

U.L. listed conduit connector and power supply cable

2-6