REMOVING AN ELEMENT & LIMITER AND THE HOT SURFACE INDICATOR ASSEMBLY

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

1.Unplug range or disconnect power.

2.Remove the control panel from its subchassis, (see page 4-2 for the proce- dure), and rotate it forward onto the cooktop glass.

3.Remove the five screws and flat washer from the control panel subchassis.

5.To remove an element and limiter:

a)Remove the wires from the element and limiter terminals.

b)Remove the screw, or pull the end of the retaining rod out of the bracket, and remove the element and limiter from the bottom of the cooktop.

2 Screws

Subchassis

 

Screw & Flat Washer

2 Screws

 

 

 

4.Move the control panel back into place over the chassis, then lift the front of the cooktop assembly, and prop it up with a piece of board so that you can access the components (see the photo at the top of the next column). CAUTION: Be careful that the cooktop does not accidentally fall.

Retaining Rod

(Pull Out)

Retaining

Rod Screws

4-5

Continued on the next page.

Page 31
Image 31
KitchenAid KESC300H, KESH307H, KESC307H manual To remove an element and limiter, On the next