KitchenAid KESC300H, KESH307H, KESC307H manual Line

3-Wire Electrical Connection

Use this method only if local codes permit con- necting a cabinet-grounded conductor to the neutral wire of the power supply cord.

NOTE: Do not loosen the factory-installed nuts on the terminal block when you perform the following steps.

1.Connect the neutral (white) wire of the power supply cord to the center, silver-

colored terminal screw on the terminal block, and secure it with one of the 3/8″ brass nuts that you set aside earlier.

2.Connect the remaining two power supply

cord wires to the outer terminals of the terminal block, and secure them with 3/8″ brass nuts.

3.Tighten the strain relief screws to secure the power supply cord.

4.Install the terminal block cover.

silver-colored terminal block screw

	line 2
ground	neutral wire
link	(white wire)
line 1	U.L. listed conduit
	connector and power
	supply cable

2-7