REMOVING A SIDE PANEL
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Unplug range or disconnect power.
2.Pull the range away from the wall so that you can access the rear of the unit.
3.Remove the oven door and set it aside (see page
4.Pull the storage drawer out as far as it will go.
5.Remove the two rear screws from the side panel.
Screw
Side Panel 
6.From the rear of the unit, reach inside and remove the screw from the bottom of the side panel.
Remove Bottom
Side Panel Screw
7.Slide the side panel forward and unhook the front edge, then tilt the top of the side panel out, and lift the panel from the unit.
Slide Forward & Tilt
Top Of Panel Out
Screw (Inside)
Screw
NOTE: When reinstalling the side panel, set the bottom edge on the rail, hook the front edge at the top and bottom, and install the two rear screws; then install the bottom screw from inside the rear of the unit.
