Maxtor NVR-2028 manual Wireless Network Structure of the NVR and Its LANCAMs, 192

xi.Push the Setup button to save the setup data.

xii.When the words "WAITING" flash on and off at the bottom of the screen, if the screen goes blank, you can press the "Power" button to close the device and press it again to resume its operation.

6.Go to the IP/ACCOUNT option on the LANCAM SETUP page in the NVR setup menu. Choose any channel between 1 to 8 channels to set up the LANCAM IP address. Push the Search button to find all LANCAM IP addresses and push the Enter button to choose one of them to set the channel. Repeat step 6 to set each LANCAM IP address.

NOTE: You need to use an RS-232 cable enclosed in our package and not any other cable, or an error may happen.

NOTE: Once the LANCAM power cord is plugged into the outlet, it will scan the AP or NVR device automatically and obtain an IP address from a DHCP server. This action will continue until a DHCP server is found. If the LANCAM cannot find it after two minutes, its IP address will change to static IP mode as 192. 168. 1. 168. The user can push the DHCP DIP switch on the side of the LANCAM down and up once to reset the static IP to dynamic IP (DHCP client).

NOTE: If the DHCP server of the NVR-2028 is activated, the default NVR IP address is set as

192.168. 1. 205.

3.1.2The Wireless Network Structure of the NVR and Its LANCAMs

The illustration below shows the wireless network of a WIRELESS NVR-2028device connected with its LANCAM client units, whose maximum number is eight.

wireless Lancamwireless Lancam

	(UP TO 8 WIRELESS LANCAMS CONNECTION)
wireless Lancam	wireless Lancam

				ANT
Audio in	WAN	LAN
				SD Card
Video in				RS-232
		MONITOR	AUDIO	ALARM I/O

MonitorNVR

DC12V

12