Maxtor NVR-2028 manual RJ-45 PIN configuration for Ethernet, PIN no, PIN Assignment, Tx + Rx +

RJ-45 PIN configuration for Ethernet		RJ-45 socket
PIN NO.	PIN Assignment
1.	TX +
2.	TX -
3.	RX +		1 2 3 4 5 6 7 8
4.	Not Connected
5.	Not Connected
6.	RX -
7.	Not Connected
8.	Not Connected
Physical specification for Ethernet
Wire Type	Cat. 5
Connector Type	RJ-45
Max. Cable Length	30 m
Hub Wiring Configuration	Straight Through
PC Wiring Configuration	Cross Over

NOTE: If you use the wireless function, you need to know the correct ESSID and WEP KEY of the NVR concerned. Now select the ESSID and enter the WEP KEY of the laptop.

10.1.2 Install the Network Viewer in your PC

Install the Network Viewer from the supported CD-R.

1.Exit all applications currently running in the selected PC.

2.Insert the supported CD in the CD-ROM drive. The program will execute the installation automatically. Follow the on-screen instructions to proceed with the rest of the installation procedure as they appear.

3.After the installation is complete, pop up the START menu from your computer, and point to Programs

/Wireless NVR Network Viewer to open up the program selection page as shown below. Click the Wireless NVR Network Viewer tag to start the Wireless NVR Network Viewer program.

Install the Network Viewer for the ZIP file.

1.Save the ZIP file to your PC and extract the file to a designated directory.

2.Open the extracted folder.

3. Click on the icon to execute the installation and then follow the on-screen instructions as they appear to proceed with the rest of the installation procedure.

4.After the installation is complete, pop up the START menu from your computer, and point to Programs

/Wireless NVR Network Viewer to start the Wireless NVR Network Viewer program.

NOTE: Please make sure the TCP/IP communication software has been properly set and configured in your computer. To check your TCP/IP settings, refer to the following document.

66