![](/images/new-backgrounds/1215307/21530725x1.webp)
3. INSTALLATION
3.1 Basic Connection
Please follow the instructions below to connect your WIRELESS
3.1.1 Use a RS-232 cable to install a wireless setting in a LANCAM
Use a
NVR
ANT
WAN LAN
SD Card
MONITOR | AUDIO | ALARM I/O |
DC12V
I/O
VIDEO
DC 5V
wireless Lancam
1.Set up all components to both the NVR and LANCAM.
(Screw up the antenna to both the NVR and LANCAM. Screw up the Lens every LANCAM.)
2.Connect the Monitor to the NVR with a BNC cable.
3.Power on the NVR: plug the NVR power cord into the outlet.
4.Power on every LANCAM: plug every LANCAM power cord into the outlet. Make sure the NVR must power on first before this procedure.
5.Register LANCAM to the NVR:
i.Connect the NVR and one of the LANCAMs by the
ii.Press the Setup button to enter the "MAIN MENU" page.
iii.Select the item titled “COMMUNICATION” and presses the Enter button to access the "COMM. SETTING" page.
iv.Select the item termed "WIRELESS" and push Enter twice to access the "WIRELESS SETTING" page.
v.Choose the item labeled "OPERATION" and press Enter twice to go to the "OPERATIONAL SETTING" page.
vi.Select the item titled "ESSID" and push "Enter" twice to get into the "ESSID SETTING" page.
vii.Give "ESSID" your local wireless network name, and use the "<", ">", "^" and "v" buttons to change the existing letters to your network name.
viii.Press Enter, select "OK" and go to the "WIRELESS PAGE".
ix.Push Enter to access the "WIRELESS SETTING" page and go to the item termed "LANCAM SETUP".
x.Press Enter, choose
11