Kodak 8650 manual Operating the printer, Specifying the printer’s SCSI ID raster mode, October

Operating the printer

The following submenus are available only if the Network Interface Card is installed:

•PORTS:ETHERTALK—lets you specify whether version 1 or 2 of AppleTalk will be used

•PORTS:IPX—lets you specify the framing type to expect when using Novell Netware

•PORTS:TCP/IP—lets you enter the Internet address of the printer network interface card within a TCP/IP network

For complete information, refer to the Installation & Setup Guide for the KODAK Network Interface Card for the KODAK XLS 8400 Printer, the KODAK XLS 8600/8600 PS Printer, and the KODAK DIGITAL SCIENCE 8650/8650 PS Printer.

Specifying the printer’s SCSI ID (raster mode)

This option—SCSI:TARGET— appears only on printers running in raster mode. The SCSI ID default value is 5.

Select an ID that is not in use on the SCSI bus for any other purpose. For example, do not use the SCSI ID for your hard drive (0 for Macintosh computers, 7 for computers running Microsoft Windows). Similarly, do not use the ID for an external hard drive used for font storage or the ID of a scanner connected to the computer.

Specifying the SCSI connection (PostScript mode)

This option— SCSI:INITIATOR —appears only on printers running in PostScript mode. The SCSI ID default value is 6.

Select an ID that is not in use on the SCSI bus for any other purpose. For example, you cannot use the SCSI ID for your hard drive (0 for Macintosh computers, 7 for computers running Microsoft Windows). Similarly, you cannot use the ID for an external hard drive used for font storage or the ID of a scanner connected to the computer.

INITIATOR:ENABLE lets you determine whether the printer should act as the SCSI bus initiator. The default is NO.

WARNING: Choose ENABLE:YES only if an external hard drive is connected to the printer. Otherwise, disk damage to the host system could occur.

October 1997 3-7