Setting up the printer
Connecting a parallel cable
To attach a parallel (Centronics) cable:
1.Make sure the computer is turned On and the printer is turned Off.
2.Connect the Centronics end (no pins) of the cable to the printer’s parallel port.
Parallel port
(PostScript or Raster Printing)
3.Connect the
4.Connect the power cord. See "Connecting the power cord" on page
5.Turn the printer On (press the power switch on the side of the printer to ).
Connecting a LocalTalk cable
You need two LocalTalk connectors and a LocalTalk cable. Do as follows to connect the computer and printer using LocalTalk cable:
1.Make sure the computer is turned On and the printer is turned Off.
2.Attach one LocalTalk connector to the computer’s LocalTalk port. Attach the other connector to the printer's LocalTalk port.
NOTE: If you are already on a LocalTalk network, you may not need
October 1997 |
